even though a pergola is heavy and difficult to move once assembled, it has to be anchored securely to the ground for a number of reasons. primary among them is safety. a poorly anchored pergola can be moved by high winds if there is a canopy or cover on it as this adds to the wind load the pergola .
uneven posts or posts that do not stand straight up look sloppy, and it may be impossible to attach boards to the posts . the plans for this project build an 8-foot-tall and 6-foot-wide two-post arbor . hammer a stake in the highest part of the ground near one of the orange spots that you spray-painted on the ground.
sloped pergola- slope away from house, higher in seating area, lower over hot tub- must clear window over mud room.
pergola or, if being sited on a patio, remove the paving where the uprights will be. level the site if the ground is uneven. measure the area of ground where the pergola is to be situated.
how to make pergola footings level with each other?? pergola design . since the footings will be below the level of the brick, and they'll be about 12' from each other, i'm wondering how to make sure they're level with each other so . i know the patio itself isn't level; it's sloped to allow for proper drainage.
build your structure. if you don't have a flat, level area, then grade the desired area by removing soil and hand tamping to level. remember to save the soil to use as fill throughout your yard or beds. also, consider locating your pergola near shade trees, especially to protect you from late-afternoon .
the key to building a long-lasting and attractive patio lies in the proper preparation of the patio base and foundation. having uneven ground to work with is a common problem and is also a relatively simple obstacle to overcome. follow these simple steps below to build your own patio on a plot of uneven .
build a platform that is level, then raise the pergola above that? . you need to either sink the treated posts into the ground and build using the posts as framework or you install footers of some nature and then build upon those . i've seen them on fairly steep hillsides with steps leading up.
sloped backyard. it was not safe for us to use deck blocks on that back line. instead, we had to set concrete buried post footings. we didn't escape from digging, and it had to be done way down into the ground, below the retaining wall. the exterior frame was done with 2 x 8 x 16 pressure treated .
patio site. 1. measure the slope of the patio to determine if you need to do grading work before you start your project. first, drive stakes at each end of the project area. attach a mason's string between the stakes and use a line level to set it at level. at each stake, measure from the string to the ground.
slope so your deck will rest firmly and safely. the seven foot rule is a good starting point.